Redline Communications Inc. SC1000E 用户手册
User
BASE
STATION
Manual
Doc #70-00100-01-00-DRAFT
Proprietary Redline Communications © 2009
Page 8 of 60
January 7, 2009
1.4
Safety Advisories
1.
Read this manual and follow all operating and safety
instructions.
2.
Installation of the antenna and transceiver must be performed by professional trained
installers.
installers.
3.
Position power cables to avoid possible damage to the cables.
4.
Disconnect power before cleaning.
5.
Protect the unit by disconnecting the power if it is not used for long periods.
6.
DC power supply connection warning:
DC Power Supply Connections: Warning to Service Personnel
Caution for all models:
Units are not equipped with power switches and
activate immediately when connected to a
power source.
activate immediately when connected to a
power source.
7.
Mount the base station shelf securely in a 19-inch rack.
8.
The radio transceiver units must not be located near power lines or other electrical
power circuits.
power circuits.
9.
The system must be properly grounded to protect against power surges and
accumulated static electricity. It is the user’s responsibility to install this device in
accordance with the local electrical codes: correct installation procedures for
grounding of the transceiver unit, mast, lead-in wire and discharge unit, location of
discharge unit, size of grounding conductors and connection requirements for
grounding electrodes.
accumulated static electricity. It is the user’s responsibility to install this device in
accordance with the local electrical codes: correct installation procedures for
grounding of the transceiver unit, mast, lead-in wire and discharge unit, location of
discharge unit, size of grounding conductors and connection requirements for
grounding electrodes.
10.
DC input source must be an isolated secondary DC SELV supply (60V DC max).
11.
This equipment must be installed in compliance with relevant articles in National
Electric Code-NEC including chapter 8 (and equiv. Canadian Electrical Code CEC).
Electric Code-NEC including chapter 8 (and equiv. Canadian Electrical Code CEC).
12.
Keep all product information for future reference.
1.5
Frequency Selection
Operation in the FWA band is subject to license. The radio power and channel frequency
selections must be set correctly before the installed system is allowed to transmit. The
installed system must comply with all governing local, regional, and national regulations.
Contact authorities in the country of installation for complete information regarding the
licensing regime and operating restrictions for that regulatory domain.
selections must be set correctly before the installed system is allowed to transmit. The
installed system must comply with all governing local, regional, and national regulations.
Contact authorities in the country of installation for complete information regarding the
licensing regime and operating restrictions for that regulatory domain.
Declarations of conformity are available at the following web site address: