Itron I2103G 用户手册
SSI I210 3G SmartMeter User Guide
14
5 Requirements and Compliance
The SSI I210 3G SmartMeter is compliant with all applicable Federal Communications Commission (FCC)
requirements. The FCC identification numbers for the SSI I210 3G SmartMeter are listed as follows:
requirements. The FCC identification numbers for the SSI I210 3G SmartMeter are listed as follows:
FCC identifier: QHC-I2103G
IC Identifier: 4393B-I2103G
IC Identifier: 4393B-I2103G
This certification is granted to SmartSynch Inc.
5.1 FCC Grant Statement
The antennas used for this transmitter must be installed to provide a minimum separation
distance of 20 cm from all persons, and must not be co-located or operate in conjunction
with any other antenna or transmitter.
distance of 20 cm from all persons, and must not be co-located or operate in conjunction
with any other antenna or transmitter.
5.2 Compliance Statement (Part 15.19/RSS-210/ICES-003)
NOTICE:
This device complies with Part 15 of the FCC Rules [and with RSS-210 of Industry Canada].
Operation is subject to the following two conditions:
This device complies with Part 15 of the FCC Rules [and with RSS-210 of Industry Canada].
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
NOTICE:
This Class [*] digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [*] est conforme à la norme NMB-003 du Canada.
5.3 Warning (Part 15.21)
Changes or modifications not expressly approved by GE and SmartSynch Inc. may void the FCC
authorization to operate this equipment.
authorization to operate this equipment.
5.4 RF Radiation Safety Guidelines per Part 2 of FCC Rules and
Regulations
The meter should be installed in a location where there will be a separation greater than 20 cm (8 inches)
from locations occupied by humans.
from locations occupied by humans.