Zebra Technologies Corporation AP716101 用户手册

AP 7161 Access Point Installation Guide

Warnings

• Read all installation instructions and site survey reports, and verify correct equipment installation before

connecting the access point to its power source.

• Remove jewelry and watches before installing this equipment.

• Verify that the unit is grounded before connecting it to the power source.

• Verify that any device connected to this unit is properly wired and grounded.

• Connect all power cords to a properly wired and grounded electrical circuit. Verify that the electrical circuits

have appropriate overload protection.

• Attach only approved power cords to the device.

• Verify that the power connector and socket are accessible at all times during the operation of the equipment.

• Do not hold any component containing a radio such that it is very close to or touching any exposed parts of the

body, especially the face or eyes, while transmitting.

• Do not work with power circuits in dimly lit spaces.

• Do not install this equipment or work with its power circuits during thunderstorms or other weather conditions

that could cause a power surge.

• Verify there is adequate ventilation around the device, and that ambient temperatures meet equipment

operation specifications.

• Avoid contact with overhead power lines.

• Take precautions to avoid injury from falling tools and equipment. Crews should wear hard hats in and around

the installation work site.

• Be aware of vehicular traffic in and around the installation work site.

• Do not operate a portable transmitter near unshielded blasting caps or in an environment where explosives are

present unless the transmitter is especially certified for such use.

• Refer to your site survey and network analysis reports to determine specific requirements for each deployment.

• Assign installation responsibility to the appropriate personnel.

• Identify and document where all installed components are located.

• Identify and prepare Ethernet and console port connections.

• Verify that cable lengths are within the maximum allowable distances for optimal signal transmission.

CAUTION

The maximum length allowed for PoE cables is 100 meters.