Adaptivation Inc. FH-ME 用户手册
8
Operation for AC Appliances
1. Set the FreeHand and the Transceiver Module to the same
house code. Also make sure the unit code is set to the number
1 position, unless you are plugging the applicance to be acti-
vated into another Appliance Module set to a different unit
code.
house code. Also make sure the unit code is set to the number
1 position, unless you are plugging the applicance to be acti-
vated into another Appliance Module set to a different unit
code.
2. Plug the appliance you wish to operate into the bottom of
the Transceiver and plug it into the wall outlet. Make sure the
appliance is in the "on" position.
the Transceiver and plug it into the wall outlet. Make sure the
appliance is in the "on" position.
3. Check to make sure the wattage of the appliance does not
exceed the recommended maximum amount on the back of the
Transceiver Module.
exceed the recommended maximum amount on the back of the
Transceiver Module.
4. Set the FreeHand to the desired mode of control and make
sure it is turned on by moving the OFF/TIMING DIAL to the
"on" position. . Press the top of the FreeHand or an external
switch to activate the appliance.
sure it is turned on by moving the OFF/TIMING DIAL to the
"on" position. . Press the top of the FreeHand or an external
switch to activate the appliance.
Note: If using other Appliance Modules other than the Trans-
ceiver Module, you must still have the Transceiver Module
plugged in since the FreeHand sends the RF signal to this
module first. Also make sure both the FreeHand and the Ap-
pliance Module are set to the same unit code number.
ceiver Module, you must still have the Transceiver Module
plugged in since the FreeHand sends the RF signal to this
module first. Also make sure both the FreeHand and the Ap-
pliance Module are set to the same unit code number.