Radio Systems Corp 3002646 用户手册

  www.petsafe.net 17

 : Training can begin as soon as your puppy begins eating dry treats/

kibble and is weaned. 

 : House-training, jumping, trash raiding, begging at the table or 

for teaching basic obedience commands such as down, stay 

and rewarding calm behavior. 

 : The Pee Pad Clip and the Handheld Remote both work up to 25 feet.

 : Begin by giving treats from your hand. After providing a few treats/

kibble, make a trail of treats/kibble leading to the Treat Dispenser. 

Do not dispense any treats, but allow your dog to walk up to the 

dispenser. After repeating this several times, your dog will learn to 

walk up to the Treat Dispenser without begin afraid.

 : If your dog barks or paws at the Treat Dispenser, the Dispenser can 

be secured to a wall at a level your pet cannot reach. 

 : Do not dispense any treats/kibble if your dog is barking or pawing at 

the dispenser. When your dog is quiet or not pawing, give him a treat/

kibble from your hand. Repeat, giving him a treat/kibble from your 

hand several times until he is quiet or not pawing. Gradually increase 

the interval between treats/kibble. This will extend the time of not 

pawing and not barking. Once he consistently waits for his treats/

kibble, begin treating him from the Train 'n Praise

™

 Treat Dispenser.

 : Check to see if the Treat Dispenser has been turned on. 

 : Check to see if the batteries are low in the Treat Dispenser – the LED 

will flash red.

 : Check the battery in the Handheld Remote.

 : Replace the batteries.

 : If your Treat Dispenser still does not respond, contact the Customer 

Care Center.

 : Ensure you are using only PetSafe

®

 Train 'n Praise

™ 

Moisture 

Detection Pee Pads.

 : Ensure the Pee Pad Clip is in the designated area outlined on the 

pee pad.

 : Check for low batteries in the Treat Dispenser and in the Pee Pad Clip.

 : Replace the batteries.

 : If your Treat Dispenser or Pee Pad Clip still does not respond, 

contact the Customer Care Center.