Radio Systems Corp 33611130 用户手册

If you have problems with your Innotek® Spray Commander® Remote Control System:

1.  Make sure that both the device (receiver collar) and the transmitter (remote) have the same ID 

number (01 to 08) (ex. R912 ID 03 for the receiver, and T912 03 for the transmitter).

2.  Place a new battery into the receiver collar. Fill the device, then turn it on.

3.  Press button 1 on the remote control; the receiver collar should emit a beep.

4.  Press buttons 2 and 3; the receiver collar should release a small spray (button 2), and a large one 

(button 3). If nothing happens when pressing buttons 1, 2 or 3, there may be a problem with either 
the transmitter or the receiver circuits.

5.  If any of the 3 buttons produces a reaction in the receiver collar, then the transmitter is working.

6.  However, if no spray is released with buttons 2 and 3, but button 1 activates the sound signal, then 

the batteries could be low, or the device may not be fi lled properly. If all is fi ne in both cases, then 
there could be a problem with the spraying mechanism on the receiver collar.

7.  If both spray buttons work, but no sound signal can be heard when pressing button 1, then the 

piezo buzzer may be faulty.

8.  If the device doesn’t seem to hold its contents, or gas can be heard leaking from the collar, please 

contact our Customer Care Center (Centre).

1.  The Innotek® Spray Commander® is not a toy. Keep it away from the reach of children. Use it only 

for its training purpose.

2.  The Innotek® Spray Commander® must be used only on healthy dogs.  We recommend that you 

take your dog to a veterinarian before using the Innotek® Spray Commander® if he is not in good 
health.

3.  The receiver collar is waterproof.  It is however recommended to keep device away from water as 

much as possible.  Note that the remote control handle is not waterproof.

4.  Keep the device clean at all times. Simply use a dry cloth to wipe away dirt.

5.  Do not leave your device unattended where your dog could get a hold of it and damage it through 

chewing.

6.  Always make sure that the batteries you are using are still adequate to operate the device. The 

device requires 6-volt alkaline batteries, easily available from Innotek®.

7. Never 

fi ll the device with any other substance than the one provided by Innotek®. Using another 

substance, as well as opening the device, will void the manufacturer’s warranty.

8.  If your dog tries to take off  the device, a harness can be used instead of the collar provided in the kit. 

9.  The hypo-allergenic spray can is a pressurized container. Do not pierce it, heat it or dispose of it in a 

fi re as it may explode. Please read instructions on the can.

10. Do not expose the device neither to freezing temperatures nor to conditions warmer than 

113°F/45°C. Be particularly careful not to leave the device in direct sunlight, either by a window or 
in a car on a summer day, etc.

11.  Do not attempt to repair the device yourself. This will invalidate the warranty and  make repairing 

more diffi

  cult. If the device doesn’t work, please contact our Customer Care Center (Centre).

The device is activated by radio signals sent by the Innotek® Spray Commander® remote control. 
The strength of the signal may be aff ected by environmental conditions, topological features and 
electromagnetic interference. 

This being a radio frequency device, battery consumption can be elevated.

If you experience any of the above mentioned problems, please contact our Customer Care Center (Centre).