FreeWave Technologies Inc. 1521131FFF 用户手册
Spread Spectrum Wireless Data Transceiver User Manual
LUM0002AG Rev A
Version 7.0
54
RF Board Level Pinout
The RF Board Level transceivers are available in both TTL and RS232 versions.
The TTL versions use reverse polarity from standard RS-232 at 0 to 5 Volt levels. All pin descriptions and
pin numbering are the same as the RS232 version. The RS232 versions use standard RS232 polarity and
voltage levels for all of the RS232 signal lines (DTR, Transmit Data, Receive Data, Carrier Detect, RTS,
and Clear to Send) and TTL standard polarity and voltage level for the Interrupt pin.
pin numbering are the same as the RS232 version. The RS232 versions use standard RS232 polarity and
voltage levels for all of the RS232 signal lines (DTR, Transmit Data, Receive Data, Carrier Detect, RTS,
and Clear to Send) and TTL standard polarity and voltage level for the Interrupt pin.
Pin 1: B+ Power input.
Pin 2: Interrupt (INT) – Input – A 0 volt level on this pin will switch the radio into Setup mode.
Pin
Assignment
Color on ACS3610xx cable
1 B+
input
Red
2
Interrupt (temporarily ground to invoke menu)
Brown
3
Data Terminal Ready (DTR)
Orange
4 Ground
Black
5
Transmit Data (TXD)
Yellow
6 Ground
Black
7
Receive Data (RXD)
Green
8
Carrier Detect (DCD)
Blue
9
Request to Send (RTS)
Violet (purple)
10
Clear to Send (CTS)
Gray
Note: Pin 1 on the board level transceiver is the pin farthest from the three LED’s and pin 10 is closest
to the LED’s.