Renishaw plc RMP60 用户手册

Setup is done by using the RMP60 trigger logic

and powering on the RMI at a particular time

during the process.

Trigger logic is a method that allows user

configuration of the options available in the

RMP60. Trigger logic uses a sequence of

RMP60 triggering and battery insertion

followed by further RMP60 triggering.

This leads the user through a series of choices

allowing selection of the required options.

Reviewing of choices made can be made by

battery insertion alone. See pages 12 and 13 for

full details of reviewing probe settings and

configuration using trigger logic.

1.

Use trigger logic to set RMP60 turn on/ off

modes as desired.

2.

Use trigger logic to access RMP60

acquisition mode (light blue flashes, 2 short

1 long).

RMP60-RMI partnership

3.

Power on the RMI.

4.

Wait until RMI signal led flashes green.

5.

Trigger the probe (min 0.1 sec max 2 sec)

RMP60 will flash 2 x turquoise short,

followed by 1 red long and repeat until

acquistion occurs.

6.

RMI pattern will change to red & yellow

flashing when it acquires the RMP.

7.

Allow ~10 seconds for both RMP60 and

RMI to timeout all RMP60 LEDs off and RMI

signal LED off. The system is then ready for

use.

When holding the RMP60 do NOT wrap

a hand, or anything else, around the

glass window.

continued on next page