Chungear Industrial Co Ltd CE10010 用户手册

1.  This unit finished learning process inside manufactory, if replace transmitter or receiver, user 

need to redo learning process before using this unit.   

2.  Open battery cover (with battery, DC9V 1pcs, installed) and use a ball pen to set Code switch 

up or down (Fig. 1). Then turn ceiling fan power on, press transmitter “FAN OFF” key over 

5seconds, down light will be flash twice, which indicate that learning process finished. Learning 

effect distance is same with remote’s. Please note that must press the “FAN OFF” key within 

30sensonds after power on. If just replace batteries, no need to re-learn. 

3.  Please note that the transmitter can learn in multiple receiver, when doing learning process 

please make sure not learn in other receiver. Suggest to separate power switches of fans in 2 

meter range. 

                                                                               

1.  If installed energy light onto ceiling fan down light, please slide the “down light function select 

switch” to “O” position (Fig. 2). If installed tungsten light onto ceiling fan, please slide the “down 

light function select switch” to “D” position. 

 

                                                           

FUNCTIONS OF TRANSMITTER                                   

LIGHT     : ON/OFF- Press and release immediately to turn on or off 

the light.   

           DIMMER-Press and hold to dim or brighten light    

                                        to the desired level and release.         

(Tungsten only and down light function select   

switch” to “D” position.)   

FAN OFF        : Turn off the ceiling fan. 

HI           :Turn on the fan at high speed 

MED        :Turn on the fan at medium speed                            

 

LOW        : Turn on the fan at low speed 

REVERSE   :

 

Press and release immediately to set   

fan wind direction up or down. 

                                                                                             

Installation of 

Transmitter Wall 

Mount Holder with 

two screws. 

Fig. 1 

Fig. 2