R F Technologies Inc PCFSZ24 用户手册

Chapter 1: Equipment Overview 

18

Series 5.0 Software (0510-1059-A_DRAFT) - User Guide

1.    Mount and test the Smoke Detector according to the manufacturer’s instructions.

2.    Activate the Smoke Detector by placing it in alarm. Press the Test/Silence button until the LED lights 

or the sounder activates (about 4 seconds).

3.    If the Smoke Detector is working properly, a Smoke alarm event will be listed on the Event List at the 

Central Server. The system senses the Smoke Detector when it goes into alarm and adds it to its list of 
devices.

4.    Reset the alarming device by pressing the Test/Silence button until the LED lights or the sounder 

activates (about 4 seconds).

If the alarming device is reset properly, the alarm event will automatically clear from the Event List at 

the Central Server. If Enforced JCAHO is enabled, you must clear the alarm at the Central Server.

5.    At the Central Server, update the Smoke Detector information, for example, giving it a name and/or 

assigning it to a room or unit. Refer to the “Update Devices” section in the Series 5.0 Software 
Administrator Guide.

An Asset transceiver is a wireless, mobile transceiver that is attached to an asset. 
An event is reported in the Event list when an attempts is made to remove the 
asset from an Exit Zone. The Asset transceiver is supervised; if no information is 
received by the system from the transceiver for a specified number of minutes, a 
Device Fault alarm is generated in the Event List.

The Asset transceiver is equipped with and powered by a 3V battery with a 3 to 
5-year life, based on use. Following these instruction to set up the Asset 
transceiver for use.

1.    Place the Asset transceiver in alarm. Move the Asset transceiver to an Exit Alarm Zone and open a 

monitored door.

2.    If the Asset transceiver is working properly, a Door alarm event will be listed on the Event List at the 

Central Server. The system senses the Asset transceiver when it goes into alarm and adds it to its list of 
devices.

3.    Reset the alarming device.

If the alarming device is reset properly, the alarm event will automatically clear from the Event List at 

the Central Server. If Enforced JCAHO is enabled, you must clear the alarm at the Central Server.

4.    At the Central Server, update the Asset transceiver information, for example, giving the Asset transceiver 

a name and/or assigning it to a room or unit. Refer to the “Update Devices” section in the Series 5.0 
Software Administrator Guide.