Actiontec Electronics Inc. SBWD960A 用户手册
53
2. Select a desired value from the Group Owner Intent drop-down box.
Note: The larger the value is, the more likely the receiver becomes the group owner of the
P2P connection.
3. Click the Apply button, and then click OK on the pop-up message box to confirm.
4. The receiver reboots, and new settings take effect after the reboot.
5.3.25.
Setting up P2P Network Parameters
When AGO is enabled, you can define network parameters for peer to peer connection,
including P2P Wireless Network Name (SSID), Password, IP address, subnet mask, DHCP
IP address range.
You should configure these parameters when you use the Managed Meetings function.
When source devices connect to the receiver, the receiver will assign IP addresses to these
devices. And these IP addresses are defined by the parameters discussed in this section.
Follow the procedure below to set up the receiver
’s P2P network parameters:
1. Go to the Network Settings tab page by clicking the Network Settings tab.
2. Go to the Wireless Interface Settings section, and properly configure the network
parameters.