Lodar LTD P121 用户手册
TX5008
F1
F2
Function uttons
b
SET
Button activates the
Receiver and the keypad
function buttons
2 r
s
elease crews for
attery ompartment
b
c
at rear.
x
Alkaline batteries
2 AAA
Effective working range up to a distance of
60 metres (200 feet) 50 Series
The ransmitter automatically
t
transmits a
signal after
STOP
30 minutes; this de-activates
the eceiver and the ransmitter.
the eceiver and the ransmitter.
r
t
SAFETY FEATURE
!
50TX.0 E.A4
6
!
Instructions for Series
Transmitters
50
Mini
(
)
8 Function shown
LED
Blinks when ransmitter
Blinks when ransmitter
t
is active.
when a ransmitter
ON
t
utton is pressed.
b
while transmitting
Pulses
when attery is low.
when attery is low.
b
b
STOP utton switches off
the eceiver and the keypad
the eceiver and the keypad
r
function buttons
PRESS HOLD
&
both
(Red)
STOP
and
(Green)
SET
for a
of
MINIMUM
5 SECONDS
Then
&
PRESS
HOLD SET
for 5 seconds
To register Transmitters to the Receiver
1. Coding into Slot 1
1.
Ensure Receiver is OFF
2.
Press and hold
and
on Transmitter until LED goes
SET
STOP
OFF
3.
LED on Transmitter will flash once to indicate slot 1
4.
Turn
Receiver
ON
5.
Wait for green LED on Receiver to flash slowly
6.
Press and hold
on Transmitter until green LED on Receiver flashes
SET
quickly several times
7.
Check Receiver is coded correctly by pressing SET then operating any function
2. Coding into Slot 2
1.
Ensure Receiver is OFF
2.
Press and hold
and
on Transmitter until LED goes
SET
STOP
OFF
3.
LED on Transmitter will flash once to indicate slot 1
4.
Press
to select slot 2 – the LED on Transmitter will flash twice
SET
5.
Turn
Receiver
ON
6.
Wait for green LED on Receiver to flash slowly
7.
Press and hold
on Transmitter until green LED on Receiver flashes
SET
quickly several times
8
n
.
Check Receiver is coded correctly by pressing SET then operating any functio
If you have any problems please phone either your local Distributor or Lodar directly:-
U
U
(0)
+1-
K +44
1922 613633. US
877- 257-1581.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.