Dayton Industrial Co. Ltd. BKSTSP 用户手册

Rebel Cyclecomputers receive speed and distance from a wireless transmit-

ter mounted to the front fork.   
1.  Attach the wireless front wheel sensor and rubber mounting pad to the front 

of the left fork blade using the zip-ties provided so the battery cap is pointing 

downward.  Snug up the zip-ties but do not fully tighten them.  The sensor 

should be mounted as high on the fork blade as possible. The range of the 

transmitter is approximately 18in (46cm).  Mounting it high on the fork will 

assure good signal reception. Other mounting locations may work, but we 

feel this is the best location for most applications. 

2.  Attach the spoke magnet to a spoke on the same side of the wheel as the sen-

sor. Tighten the attachment screw just enough to hold the magnet in place 

but loose enough so that it is still movable. 

3.  Adjust the position of the sensor and magnet so they are in proper alignment 

as shown.  The magnet should pass by the sensor adjacent to the molded 

plastic line at a distance of 1-3mm. 

4.  Once everything is in alignment, fully tighten the spoke magnet in place and 

tighten the zip-ties holding the sensor to the fork. 

NR_Rebel3-5-8_eng.indd   19

3/5/08   5:24:59 PM