Wavetrend Technologies Limited L-TG500 用户手册

Link-IT “User Guide”

Page 20

Version 1.03

The Link-IT  tag uses low power Radio Frequency transmissions to communicate with the
Link-IT reader plugged into your computer. These transmissions can be adversely effected by
the environment especially the presence of metal. The result would be loss of range on your
Link-IT system. Repositioning your computer can rectify this situation. Should this approach
not rectify the situation, an extension cable is available from AIT as an accessory. Please
contact your supplier for more information. (Product code L-EC100)

It is important to set your boot sequence so that the system first boots from your primary hard
disk to ensure that the Link-IT  software will be running. This is easy to set, just follow the
steps below:

NB: This sequence might not apply to your system, if your system is different and you can not
find the boot sequence consult your PC users manual or contact your supplier.

•

 

Switch off the system (Shut Down)

•

 

Switch the system on (Power Up)

•

 

Press the delete button “Del” (some systems use “F1”, some use F2, some use Ctrl-Esc)
to go to “CMOS Setup”

•

 

Choose “Bios Features Setup”

•

 

Choose “Boot Sequence” eg. A, C, SCSI

•

 

Change the sequence so that your primary boot device boots first or that your primary
boot device is your only boot device.

•

 

Press “Esc”, go to “Save Settings And Exit”

The system will now restart, booting from your hard disk first. For additional security you
should password protect your CMOS settings.