Honeywell International Inc. 99EXLF 用户手册

14 - 7

The Dolphin terminal is usually auto-detected and configured by ActiveSync or Windows Mobile Device 
Center based on the communication cable. The synchronization software automatically sets up an 
RS232 connection when you are using an RS232 cable.

For more details, see 

Connect the base to the host workstation or other device by plugging an RS232 serial cable into the 
RS232 Communications Port on the bottom of the base. Plug the other end of the RS232 serial cable 
into the correct port on the host RS232 device. The wiring of your cable depends on whether the other 
device is set up as a Data Communications Equipment (DCE) or Data Terminal Equipment (DTE) 
device. 

The Communication Port is configured as a DCE device. To communicate with a DTE device such as a 
workstation, use a standard (or straight-through) RS232 cable. To communicate with a DCE device, use 
either a null modem adapter in line with a standard RS232 cable, or a null-modem serial cable. 

You can make your own cables by following the pin configuration in the chart that follows. To do so, you 
must determine if your host RS232 device is 9-pin or 25-pin, and whether it is configured as a DCE or 
DTE device.

Note: The input signal names are reference to the DTE target device (i.e., workstation or host computer) in 

accordance with the RS232 standard.

2

3

2

3

2

3

5

7

7

4

20

6

6

6

20

7

4

5

8

5

4