Honeywell International Inc. CS19A 用户手册
6 - 2
Step 3. Terminal Type
Refer to
(page 6-4) and locate the Terminal ID
number for your PC. Scan three numeric bar codes on the inside back
cover to program the scanner for your terminal ID (you must enter 3
digits). For example, scan 0 0 3 for an AT wedge.
cover to program the scanner for your terminal ID (you must enter 3
digits). For example, scan 0 0 3 for an AT wedge.
Note: The wildcard for all terminal types is 099.
Step 4. Code I.D.
which you want to apply the data format. Locate the Hex value for that
symbology and scan the 2 digit hex value from the
symbology and scan the 2 digit hex value from the
inside the back cover of this manual.
Step 5. Length
Specify what length (up to 9999 characters) of data will be acceptable
for this symbology. Scan the four digit data length from the
for this symbology. Scan the four digit data length from the
inside the back cover of this manual. (Note: 50
characters is entered as 0050. 9999 is a universal number, indicating
all lengths.)
all lengths.)
Step 6. Editor Commands
Refer to (page 6-4). Scan the symbols that represent the command you
want to enter. 94 alphanumeric characters may be entered for each
symbology data format.
want to enter. 94 alphanumeric characters may be entered for each
symbology data format.
Step 7.
Scan Save to save your data format, or Discard to exit without saving
your changes.
Enter Data Format
Save
Discard
Preliminary Draft