Honeywell International Inc. CS19A 用户手册

13 - 4

If the scanner reads a bar code, but the data is not displayed correctly on 
the host screen:

• The scanner may not be programmed for the appropriate terminal 

interface. 
For example, you scan “12345” and the host displays “@es%.”

Reprogram the scanner with the correct Plug and Play bar code.  See 

• The scanner may not be programmed to output your bar code data 

properly.
For example, you scan “12345” and the host displays “A12345B.”

Reprogram the scanner with the proper symbology selections.  See 

.

1. Scan the sample bar codes in the back of this manual.  If the scanner 

reads the sample bar codes, check that your bar code is readable.
Verify that your bar code symbology is enabled (see 

2. If the scanner still can’t read the sample bar codes, scan 

If you aren’t sure what programming options have been set in the scanner, 
or if you want the factory default settings restored, refer to 

Note: Visit the Services and Support section of our website 

) to check for the latest software for both 

the scanner and the base.

If your base is not functioning properly, review the following troubleshooting 

guidelines to try to isolate the problem.

If the red LED isn’t illuminated, check that:

• The power cable is connected properly and there is power at the power 

source.

• The host system power is on (if external power isn’t used).

If the 

green LED isn’t illuminated, check that:

• The scanner is correctly placed in the base.
• There is external power or 12 volt host power.
• Charge mode is turned on.  (

)

Preliminary Draft