Honeywell International Inc. 4230A 用户手册

Batteries are shipped discharged and need to be fully charged prior to first use. 

The battery is a lithium ion cell and can be used without a full charge. It also can be 

re-charged without fully discharging, without impacting the battery life. There is no 

need to perform any charge/discharge conditioning on this cell type battery. 

Do not disassemble the battery. There are no user-serviceable parts in the battery. 

Replace a defective battery immediately since it could damage the IT4230. 

Don’t short-circuit a battery or throw it into a fire. It can explode and cause severe 

personal injury. 

Although your battery can be recharged many times, it will eventually be depleted. 

Replace it after the battery is unable to hold an adequate charge. 

If you are not sure if the battery or charger is working properly, send it to Hand Held 

Products or an authorized Hand Held Products service center for inspection. 

 

When the battery has reached the end of its useful life, the battery should be disposed of 

by a qualified recycler or hazardous materials handler. Do not incinerate the battery or 

dispose of the battery with general waste materials. You may send batteries to Hand 

Held Products (postage paid). The shipper is responsible for complying with all federal, 

state, and local laws and regulations related to the packing, labeling, manifesting, and 

shipping of spent batteries. Contact the 

Product Service Department 

(page 12) 

for recycling or disposal 

information. Since you may find that your cost of returning the 

batteries significant, it may be more cost effective to locate a local 

recycle/disposal company. 

The IT4230 imager may be used with other Bluetooth devices. If the imager goes out of 

and back within range of the Bluetooth device, it automatically reconnects to the device. 

 

The following Bluetooth adapters have been verified to operate with the IT4230.