Honeywell International Inc. 760002 用户手册

There are two ways to reset the Dolphin terminal: a soft reset and a hard reset. 

A soft reset re-boots the device without losing RAM data. 

You would perform a soft reset 1) when the terminal fails to respond, 2) after installing software applications that require a reboot, 
or 3) after making changes to certain system settings.

1. Press and hold Red 

 + ESC 

 for approximately 5 seconds. The screen turns white and the decode and scan LEDs 

flash for approximately three seconds. 

2. When the reset is complete, the Desktop appears.

A hard reset erases all of the data and applications stored in RAM memory and launches Autoinstall, which re-initializes the 
terminal.

Hard resets automatically launch a soft reset as part of the boot process.

1. Press and hold Red 

 + TAB 

 for approximately 5 seconds. The screen turns white and the decode and scan LEDs 

light for approximately three seconds. 

2. The terminal re-initializes, which re-installs all programs stored in the \IPSM\Autoinstall folder.

Note: Set the time and date after each hard reset to ensure that the system clock is accurate. Tap the date on the command bar 

to open the Clock setting and set the time and date. 

Suspend mode suspends terminal operation. The terminal appears to be “off” when in suspend mode. The terminal is 
programmed to go into suspend mode automatically when inactive for a specified period of time. You can set this time period in 
the Power setting.

Press the Blue  

+ 

Backlight  

keys. 

Note: You should always put the terminal in suspend mode when you change the battery pack; see 

To resume terminal operation (or “wake” the terminal from suspend mode), 

•

Press the Blue  

+ 

Backlight  

keys.

OR

•

Press the Scan key 

.

If the terminal does not wake when you press the Scan key, the main battery might be too low to resume operation. To check, 
remove the battery and install a fully charged battery or connect the terminal to a Dolphin charging peripheral.

!