Honeywell International Inc. 85606065 用户手册

3 - 4

Connecting the Power and Communication Cables

The IK8560 features a standard power cable that connects to a number of communication cables to suit your environment.

Standard Power Cable

The standard power cable powers the device and with an AC power adapter to convert the voltage from the power source to the
voltage required by the device. The IK8560 device must be connected to external power to run.

Communication Cables

The IK8560 offers the following communication options:

•           USB Cable (four feet)
•           Standard RS-232 Cable (12 feet)
•           RS-232 Pass-Through (Y cable)

Note: You can verify the status of the communication cable by the icon in the task tray; see

Task Tray Icons

on page

2-2.

USB Cable

The USB communication cable is four feet long and supports USB 1.1. You can connect USB 2.0 devices that are backwards
compatible with USB 1.1 with this cable but data transfer will occur 1.1 speeds.

It features a single, 15-pin male connector that plugs into the DB15-pin female port on the back panel. The other end features a
standard Type A USB (1.1 or higher) connector designed to fit standard USB ports.

Note: Make sure the power switch is

turned off on the computer where
you will be installing the IK8560.

Host

1. Plug the 15-pin connector (HDB15) of

the communication cable into the back
of the IK8560.

2. Plug the USB connector into the port

on your host workstation.

3. Plug the power plug into the pod on

the communication cable.

4. Plug the AC power supply into a power

outlet.

Hardware installation is now complete.
Your IK8560 powers on and auto-
configures to USB.

When you power on the host workstation,
you need to complete the Found New
Hardware wizard and install the IK8560
driver to configure the workstation for
ActiveSync communication; see

If you want to power the device without communicating, simply disconnect the USB connector from the host workstation.