Unitech Electronics Co. Ltd. PA690BTGGR 用户手册

下载
页码 46
 
 
Copyright 2011 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
 
Installing the Battery 
WARNING!
 There is a risk of fire and burns if the battery pack is handled 
improperly. DO NOT disassemble, crush, puncture, short external 
contacts, or dispose the battery pack in fire or water. DO NOT 
attempt to open or service the battery pack. Dispose of used 
batteries according to local recycling guidelines in your area. 
A backup battery cell is embedded into your device to prevent data loss when 
the main battery pack is removed or completely discharged. This backup 
battery will keep the data and system setting for up to 2 hours if the main 
battery is removed. 
NOTE: To enable the backup battery cell to provide backup power supply, 
charge your device with the main battery pack for at least 16 hours. 
NOTE: To power on the device properly, make sure to replace the battery 
compartment cover after installing the battery. 
1.  Open the battery compartment 
cover by sliding the tabs on both 
sides in the direction of the arrows 
shown and lift the cover up. 
 
2.  Push up the backup battery switch   
to the “ON position by using a 
stylus to turn on the backup 
battery. 
 
3.  Slide and position the battery 
pack, making sure the battery 
contacts are aligned with the 
contacts in the compartment. 
 
4.  Use your thumb to snap the 
battery in place. 
 
Battery Compartment Tab 
Backup Battery 
Switch 
Battery 
Compartment 
Contacts 
Plastic Tab