Agfa Gevaert N V 5365 用户手册
42
2921B EN 20031206
Checking the correct position of a film in the input tray
"
You can verify that the film is properly loaded by watching the lower right
corner of the films in the input tray. The rounding of this corner should be
smaller than the other three corners. This is also indicated on the sticker
at the right side of the input tray cover.
corner of the films in the input tray. The rounding of this corner should be
smaller than the other three corners. This is also indicated on the sticker
at the right side of the input tray cover.
"
When a new film is loaded, the Film Identification tag is read and the
printer settings are automatically adjusted. The Film Identification tag is
located on the protective sheet on the backside of the film pack. The
figure below shows the film pack upside down.
printer settings are automatically adjusted. The Film Identification tag is
located on the protective sheet on the backside of the film pack. The
figure below shows the film pack upside down.
1
3
2
4
5
6
XXXXXX
XXX
X XXX
XXX
XXXXXX
XXX
X XXXXX
X
XXXXXX
XXX
X XXX
XXX
XXXXXX
XXXX
XXXXXX
XXXXXX
XXX
X XXX
XXX
XXXXX
X XXX
X XXX
XXX
XXXXXX
XXXX
XXXXXX
XXXXXX
XXX
X XXXX
XX
XXXXXX
XXXX
XXXXXX
XXXXX
X XX
XX XXX
XXX
XXXXXX
XXX
X XXXX
XX