Honeywell International Inc. RTU-B07 用户手册

To assemble the unit in a horizontal position, follow these steps:

1. Drill two holes in the wall (to accommodate the 2 plastic dowels),

so that the frame will cover the hole through which the cables

pass.

2. Insert the cables in the cable clamp without pulling out the screws.
3. Use the dowels to fasten the frame to the wall. Make sure that

the lamellar connector is in the UP position.

4. Adjust the length of the cables so that they protrude by ~10cm

from the wall, and fasten them to the cable crimp.

5. Fasten the cable crimp to the contacts in the direction shown in

Figure 4.

6. Place the remainder of the cable inside the frame and lock the cable

clamp.