Honeywell International Inc. THM4000R02 用户手册

© 2010 Mitsubishi Electric & Electronics USA, Inc.
Suwanee, GA 30024 All Rights Reserved.
The three diamond logo is a registered trademark
of Mitsubishi Electric Corporation
69-2426—01 M.S. 11-10
Printed in U.S.A.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1  This device may not cause harmful interference, and

2  This device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to

operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the

FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the 

instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be 

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following 

measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•

Consult the dealer or an experienced radio/TV technician for help.

To comply with FCC and Industry Canada RF exposure limits for general population/ uncontrolled exposure, the antenna(s) used

for these transmitters must be installed to provide a separation distance of at least 20 cm from all persons and must not be 

co-located or operating in conjunction with any other antenna or transmitter.

This portable transmitter with its antenna complies with FCC and Industry Canada RF exposure limits for general population/

uncontrolled exposure. This device must not be co-located or operating in conjunction with any other antenna or transmitter.

Operation is subject to the following two conditions:

1  this device may not cause interference, and

2  this device must accept any interference, including interference that may cause undesired operation of the device.

Remote Controller: 32 to 120° F (0 to 48.9° C)

Portable Central Controller: 32 to 120° F (0 to

48.9° C)

Wireless receiver: -40 to 165° F (-40 to 73.9° C)

Outdoor air sensor: -40 to 140° F (-40 to 60° C)

Remote Controller: 5% to 90% (non-

condensing)

Portable Central Controller: 5% to 90% (non-

condensing)

Wireless receiver: 5% to 95% (non-condensing)

Outdoor air sensor: 0% to 100% (condensing)

Physical Dimensions (height, width, depth)

Remote Controller: 3-9/16 x 5-13/16 x 1-1/2

inches (91 x 147 x 38 mm)

Wireless receiver: 6-7/16 x 3-1/4 x 1-5/16

inches (164 x 82.5 x 34 mm)

Outdoor air sensor: 5 x 3-1/2 x 1-11/16 inches

(127 x 89 x 43 mm)

Portable Central Controller: 6-1/4 x 3-1/8 x

1-5/8 inches (158.2 x 79.9 x 42 mm)

Item 

Portable Central Controller

MCCH1

Outdoor air sensor

MOS1

Remote Controller

MRCH1

Receiver and Cable

MIFH1

Cable 

MRC1