Royal Information Electronics Co Ltd TRLS-111 用户手册

INSTALLATION

Safety Checks

Make sure the monitor and system unit power switches are off, when

you start connecting cables. This monitor is set for 100-240 Vac 60/50

Hz (full range). Confirm the line voltage for your monitor by checking

the voltage label on the rear panel of the monitor.

Figure 3 Installing the Swivel Base

Connecting the Video Cable

The monitor comes with a built-in video cable. Plug the signal cable's

15-pin connector into the computer's video port and tighten the two

screws on the cable connector. As Figure 3.

Connecting the Power Cord

Plug the power cord into the monitor's AC power jack. Then plug the

power cord into a grounded AC outlet or UL-approved power strip.

Caution: If the AC outlet is not grounded (with three holes), install the
proper grounding adapter (not supplied).

USB Connector

(option)

This monitor provides the Universal Serial Bus (USB) to connect with

the USB cable or device.