Zebra Technologies Corporation P430I-MIFARE 用户手册

Printing a Test Card

980470-001 Rev. A

P430i User’s Manual

23

With ribbon and cards loaded, your P430i Printer is ready to print. To check the operation of the printer, you 
should print a test card. (Printing a test card does not require that the printer be connected to your computer or 
network, but power must be applied.)

Set the printer’s power switch (on the back of the printer) to the OFF ( O

 ) position.

While pressing the Printer’s front panel button (next to the LCD display panel), switch the printer ON ( |

 ).

Hold the panel button until the LCD display panel reads “SELF TEST”.

Release the panel button, and the test card will print.

This is an example of the test card:

Packing the P430i Printer for Shipment

If the P430i Printer is to be shipped, it is important to use the original packing and shipping material to prevent 
damage to the Printer. If the original material is lost, a replacement Shipping Kit can be ordered from your 
reseller.

Remove cards in the card feeder:

While the printer still has power applied and is turned on, and is still connected to the host computer, 
remove cards from the card feeder. The last card may be difficult to remove. If so, use the Eject Card 
command available through the driver on the host computer to eject the last card that is staged in the 
feeder.

Close the Card Feeder Cover.

The specifics of the shipment and the printer’s condition may influence which of the 

following steps are followed; common sense should prevail.

Caution • Do not physically pull the last card out of the feeder staging area. This could 
damage the printer and void the warranty, as well as damage the card.

Serial N°: XXXXX

Firmware: XXXXXXX

Head resistance: XXXX

Offset: XXXX-XXXX

EC:XX

Printing counter: XXXXX