Zebra Technologies Corporation W2WLAN11G 用户手册

If the wireless interface is experiencing hard errors, an indication of this will be added to the
normal status display, such as the following:

A wireless error is not considered an alarm condition, such as “Out of Cards”, so the display
does not change to ALARM. The wireless error display is simply informative. In most cases
communications with the printer will have been lost, so the wireless error condition will not be
seen by a host. The wireless errors are detailed in the following table:

Wireless Error Text

Code Description

WIFI ACCESS POINT

MISSING

19002 After power up, the printer tried to connect to the access point

specified by the wireless settings, but the access point was not

found during the scan. The printer will periodically retry to

connect to the access point.

WIFI LINK LOST

19003 The connection to the access point was lost. This may be due to

poor signal strength, interference or the access point power has

been lost. The printer will periodically retry to connect to the

access point.

WIFI INCOMPATIBLE

NETWORK

19004 After power up, the printer tried to connect to the access point

specified by the wireless settings, but found the access point

settings incompatible. This could occur if the access point

configuration is modified. To correct, re-run the Setup Wizard

to establish new wireless settings.

WIFI ASSOCIATION

FAILED

19005 During association with an access point, the association failed.

This could be a result of poor signal quality. If the signal

strength is low, take steps to improve it, then re-run the Setup

Wizard to establish new wireless settings.

WIFI CONNECTION

FAILED

19006 The key handshake following the association failed. This may be

because the WEP key or WPA passphrase is wrong. To correct,

make sure that you have the correct key passphrase then re-run

the Setup Wizard to establish new wireless settings.

READY

INFO

READY

WIFI LINK LOST
ERROR CODE = 19003

INFO