Zebra Technologies Corporation RFID-M2HF 用户手册

Connect the Printer to a Power Source

12/2/05

XiIIIPlus/R110Xi/R170Xi User Guide

13383L-002 Rev. A

The AC power cord must have a three-prong female connector on one end that plugs into the 
mating AC power connector at the rear of the printer. If a power cable was not included with 
your printer, refer to 

Power Cord Specifications on page 17

.

Turn the printer power switch to the Off (O) position.

Plug the power cord into the AC power connector on the rear of the printer.

Plug the other end of the power cord into a power outlet near the printer.

Depending on how your printer was ordered, a power cord may or may not be included. If one 
is not included or if the one included is not suitable for your requirements, refer to the 
following guidelines:

• The overall cord length must be less than 9.8 ft. (3.0 m).

• The cord must be rated for at least 10 A, 250 V.

• The chassis ground (earth) must be connected to ensure safety and reduce electromagnetic 

interference. The third wire in the power cord grounds the connection (

Figure 6

).

For personnel and equipment safety, always use an approved three-conductor 

power cord specific to the region or country intended for installation. This cord must use an 
IEC 320 female connector and the appropriate region-specific three-conductor grounded 
plug configuration.

For personnel and equipment safety, always use an approved three-conductor 

power cord specific to the region or country intended for installation. This cord must use an 
IEC 320 female connector and the appropriate region-specific, three-conductor grounded 
plug configuration.