Senstar Corporation LM100 用户手册
Using the wireless gate sensor
Senstar LM100 Product Guide
Page 41
Using the wireless gate sensor
The wireless gate sensor (WGS) operates in conjunction with the Senstar LM100 system to
provide RF-based wireless security protection for gates. The WGS is comprised of two
components. The wireless gate sensor module (GSM) is attached to the gate. The GSM analyzes
signals picked up from the fence fabric on the gate and will transmit an alarm when it detects
vibration, motion, or positional changes. A wireless gate sensor receiver (GSR) mounted on the
LM100 gateway circuit card assembly (CCA) receives the transmission and passes on the alarm
signal to the gateway. Alarm data communications are via the gateway over the Silver Network or
by contact closures.
provide RF-based wireless security protection for gates. The WGS is comprised of two
components. The wireless gate sensor module (GSM) is attached to the gate. The GSM analyzes
signals picked up from the fence fabric on the gate and will transmit an alarm when it detects
vibration, motion, or positional changes. A wireless gate sensor receiver (GSR) mounted on the
LM100 gateway circuit card assembly (CCA) receives the transmission and passes on the alarm
signal to the gateway. Alarm data communications are via the gateway over the Silver Network or
by contact closures.
Note
See E7DA0103 Wireless Gate Sensor for information on installing and
configuring the WGS.
configuring the WGS.
Figure 44: Wireless Gate Sensor example
Figure 45: Solar powered Wireless Gate Sensor with magnetic gate contact
up to 300 m
gateway with Gate
Gate Sensor
Sensor Receiver
Module