ZyXEL Communications Corporation WAP7205 用户手册
Chapter 8 MoCA
WAP7205 User’s Guide
51
8.4 MoCA Monitor Screen
Use this screen to view the MoCA network status and information about the connected MoCA devices
(nodes). Click Network > MoCA > Monitor.
(nodes). Click Network > MoCA > Monitor.
Secondary
Offset
Offset
Select the second operating frequency range if you clear the Auto Channel Selection check
box.
box.
Select None if you don’t want to specify a second channel.
Select Above to have the WAP7205 use a frequency higher than the upper edge of the
selected primary channel.
selected primary channel.
Select Below to have the WAP7205 use a frequency less than the lower edge of the selected
primary channel.
primary channel.
PER Mode
The Packet Error Rate (PER) indicates the ratio between the total number of incorrectly received
data packets and the total number of transmitted data packets. The total number of
transmitted packets is at least 100,000,000 when the PER mode is NPER (Normal PER) and at least
10,000,000,000 when the PER mode is VLPER (Very Low PER). In very low PER mode, the physical
data rate will be decreased in order to achieve a lower packet error rate.
data packets and the total number of transmitted data packets. The total number of
transmitted packets is at least 100,000,000 when the PER mode is NPER (Normal PER) and at least
10,000,000,000 when the PER mode is VLPER (Very Low PER). In very low PER mode, the physical
data rate will be decreased in order to achieve a lower packet error rate.
Select Normal to set the PER mode to NPER. Otherwise, select Very Low to set the PER mode to
VLPER.
VLPER.
Preferred NC
The Network Coordinator (NC) is a node that performs the following functions in a MoCA
network: beacon generation, MAP (Medium Allocation Plan) generation, admission of new
MoCA nodes to the network, privacy key generation and distribution, and LMO (Link
Maintenance Operation) scheduling. The NC is dynamically selected from all the MoCA nodes
in the network.
network: beacon generation, MAP (Medium Allocation Plan) generation, admission of new
MoCA nodes to the network, privacy key generation and distribution, and LMO (Link
Maintenance Operation) scheduling. The NC is dynamically selected from all the MoCA nodes
in the network.
There is only one NC in a MoCA network and the rest of the MoCA nodes in the
MoCA network are clients.
Select Enable to configure the WAP7205 as a preferred network coordinator. The preferred NC
has an advantage in the NC selection.
has an advantage in the NC selection.
Network Security Select Enable to turn on MoCA privacy. If this is enabled, all MoCA devices connected via
coaxial cables must use the same password.
Network
Password
Password
Enter the password for the MoCA network. All packets in the MoCA network are encrypted
except for beacons.
except for beacons.
Retype to
Confirm
Confirm
Enter the password again for confirmation.
Apply
Click Apply to save your changes back to the WAP7205.
Cancel
Click Cancel to reload the previous configuration for this screen.
Table 26 Network > MoCA (continued)
LABEL
DESCRIPTION