Audiotel International Limited 2-400-0001 用户手册
22
AUDIOTEL INTERNATIONAL MN400872 Issue 1 (08/04)
D
ETECT
IV User Manual
AUDIOTEL INTERNATIONAL MN400872 Issue 1 (08/04)
23
Changing the NLJD frequency
The operating frequency for an NLJD is specified by various approval bodies to minimise
interference between different users of the RF spectrum. Depending on the country of operation
one of these
The operating frequency for an NLJD is specified by various approval bodies to minimise
interference between different users of the RF spectrum. Depending on the country of operation
one of these
CE versions of the
D
ETECT
IV will operate on a frequency of 869.6MHz
FCC versions of the
D
ETECT
IV will operate in the frequency band 902MHz
to 928MHz (frequency hopping).
Where approvals allow it is possible to change the NLJD TX frequency to any channel in the range
830MHz to 1000MHz in 100khz steps.
830MHz to 1000MHz in 100khz steps.
Press the Mode CE button to reveal a Freq Tune button.
Press the Freq Tune once
The
red
selection box highlights the NLJD TX frequency displayed at the top of the screen in MHz.
Move the underline highlight to the required digit using the LEFT and RIGHT keypad
controls
Use the UP and DOWN keypad controls to change the Tx frequency up and down.
Press the Freq Tune button a second time to set the changed Tx frequency.
The
red
box highlight is returned to the previous current selection.
Note: Adjusting the NLJD TX frequency can be used to avoid interference, it has also
proved useful for defeating filtering and screening on certain types of mobile
phones.
phones.
Note It is the operators responsibility to operate equipment only on those frequencies
licensed to them.