JVC KENWOOD Corporation 33256 用户手册

|

English

English

   

|

   

•  Determine the installation position after making sure that 

the unit can communicate with the cell-phone.

•  Please do not install the unit near the dashboard, the rear 

tray, or other important components. Doing so could 
lead to injury or accident should the unit come off due to 
a shock and strike a person or an important component. 
Tapping screws should be used for mounting. 
(Attachment with velcro strips, although easy, can come 
off with a shock.)

  Check the installation position of the microphone 

(accessory 

1).

   Remove oil and other dirt from the installation 

surface.

  Install the microphone. 

  Wire the microphone cable up to the hands-free 

box with it secured at several positions using 
tape or the like.

Fix a cable with a commercial 
item of tape.

Peel the release coated paper of double-face adhesive tape 
to fix on the place shown in the left-hand example.

Adjust the direction of the microphone to the driver.

What might seem to be a malfunction in your unit 
may just be the result of slight misoperation or 
miswiring. Before calling service, first check the 
following table for possible problems.

✔  The hands-free talk volume is set at a low level.

☞  The hands-free talk volume can be adjusted 

independently. Adjust it during hands-free 
talk. 

✔  You are talking in the hand-free talk mode.

☞  No sound is heard from the rear speakers in 

the hands-free talk mode. 

call. 
✔  No beep is heard depending on the type of your 

cell-phone. 
☞  Selecting "Call Beep: ON" or "C-BP ON" (page 

11) allows you to hear the beep. 

✔  The control unit cannot display accent characters.

☞  Set the display character conversion function 

switch to "2" (page 18).

No Number/ NO-NMBER/ Incoming No Number : 

•  The calling party does not notify a caller ID.
•  There is no phone number data.

No Data/ NO DATA :

•  There is no outgoing call list.
•  There is no incoming call list.

No Entry/ NO ENTRY : 

The cell-phone has not been registered (pairing).

Disconnect/ DISCONCT/ Non Connection : 

The unit can communicate with the cell-phone.

Connect/ CONNECT/ Disconnected: 

The unit cannot communicate with the cell-phone.

HF Error 07/ HF ERR07: 

The memory cannot be accessed.
\  Turn off the power and on again. If this message still 

appears, press the reset button on the control unit. 

HF Error 68/ HF ERR68: 

The unit cannot communicate with the cell-phone.
\  Turn off the power and on again. If this message still 

appears, press the reset button on the control unit. 

Accessory 

3

Specifications subject to change without notice.

Technology

: Compliant with Bluetooth ver.1.2

Maximum power

: 4 dBm (Power Class 2)

Maximum link distance

: 10 m (30 ft)

Profiles

: HFP (Hands Free Profile)
: OPP (Object Push Profile)

Operating voltage (11 – 16V allowable) 

:  14.4 V

Current consumption

:  ?? A

Dimension (W x H x D) 

:  140 x 70 x 29 mm

5-1/2 x 2-3/4 x 1-1/8 inch

Weight

:  0.0 lbs (0.0 kg)

Antenna part

•  Do not stick the Velcro tape over the serial number.
•  If the installation place is stepped, cut the Velcro tape 

into two pieces and stick them at two positions as 
shown. 

Antenna part

Accessory 

2 (ø5 × 20 mm)