Deister Electronic GmbH TPU4030 用户手册
4. Activating the Transponder
For transportation, the transponders are set to transport mode. Before use. they must be
activated. The activation is done by an Amantag compact reader. The DIP switch B6 needs
to be set to ON position.
activated. The activation is done by an Amantag compact reader. The DIP switch B6 needs
to be set to ON position.
Attention!
Possibly, the field strength must be increased. Therefore, set DIP switch B1 to B4 to “ON”
position. After configuration, the transponder should be placed close to the reader (it
requires high power to wake up the transponder from transport mode).
As long as the switch B6 is in ON position, there is no reaction from the reader to the
transponder. Whether a transponder is active can only be revealed when the switch B6 is
in OFF position.
Possibly, the field strength must be increased. Therefore, set DIP switch B1 to B4 to “ON”
position. After configuration, the transponder should be placed close to the reader (it
requires high power to wake up the transponder from transport mode).
As long as the switch B6 is in ON position, there is no reaction from the reader to the
transponder. Whether a transponder is active can only be revealed when the switch B6 is
in OFF position.
This way, several transponders are activated simultaneously. After activation, the switches
must all be brought back into starting position.
must all be brought back into starting position.
Attention!
Once activated, transponders can not be switched into transport mode again.
Once activated, transponders can not be switched into transport mode again.
5. Acoustic Signal
The TPU 4030 has a built-in beeper, which can be activated by an Amantag compact
reader. The acoustic signal is triggered by an Amantag compact reader whenever its door
number is greater than seven.
reader. The acoustic signal is triggered by an Amantag compact reader whenever its door
number is greater than seven.
The picture below shows the switches A5 - A8 set to door number 9.
Attention!
Once activated, the alarm can only be disabled by an ADA unit (article number:
0723.000). Otherwise, the transponder will beep, until the battery is empty.
Once activated, the alarm can only be disabled by an ADA unit (article number:
0723.000). Otherwise, the transponder will beep, until the battery is empty.
6. Battery Monitoring
The battery status of the PrisonTag can be monitored. An ADA unit (article number:
0723.000) can read and display the current battery status. For more information, please
refer to the description of the ADA unit.
0723.000) can read and display the current battery status. For more information, please
refer to the description of the ADA unit.
m_en_tpu-4030-pcb_pro_v111115_de_bf
7