Roseman Engineering Ltd. FG3E 用户手册
Fleet Gate Installation Guide Roseman Engineering Ltd
9
The Fueling Division of Roseman Engineering Ltd.
3. FG3 Mounting and Installation
3.1
Mounting the FG3
1. After reviewing the recommendations listed in the Vehicle Devices Mounting
Location Considerations, mount the FG3 as follows:
If possible, mount it on the same side of the vehicle as the filler neck.
For a passenger car, the FJ3 can be mounted under the dashboard or in the
If possible, mount it on the same side of the vehicle as the filler neck.
For a passenger car, the FJ3 can be mounted under the dashboard or in the
trunk, provided that the unit is at least three running feet from the filler neck.
For a truck or bus, the FG3 can be mounted inside the vehicle's electric
enclosure.
2. Drill at least two 1/8" holes for the FG3 mounting. Use the FJ3 to mark the
holes (refer to Figure 2: FG3 Wiring Diagram)
3. Figure 2The FJ3 should be mounted on the vehicle chassis, or any other metal
portion of the vehicle whenever possible.
Do not use an electric drill or any other electrically powered
tools within three feet of the filler neck or fuel tank as this area
considered a Class I, Group D hazardous location.
tools within three feet of the filler neck or fuel tank as this area
considered a Class I, Group D hazardous location.
4. Using the two 3/8" self-tapping mounting screws and two lock washers, mount
the FJ3 to the vehicle frame. You must use two self-tapping sheet metal
screws.
screws.