Chamberlain Wireless Products Inc. PIR 用户手册
Installation:
5-20 feet
Mount 5 Feet
from ground
1. Before installing the PIR Motion Sensor Transmitter, TEACH IT
TO THE RECEIVER.
1.
Plug in the Receiver into the AC transformer.
2.
The LED on the Receiver should illuminate, indicating power is
OK.
OK.
3.
Install 4x AAA Batteries into the PIR Transmitter, paying
attention to the direction of the batteries.
attention to the direction of the batteries.
4.
As soon as the last battery is installed, the LED on the PIR PCB
should flash twice, indicating proper operation of the PIR unit.
should flash twice, indicating proper operation of the PIR unit.
5.
Press and HOLD the button on the Receiver marked TEACH.
The buzzer will sound. Continue to hold the button.
The buzzer will sound. Continue to hold the button.
6.
Press and RELEASE the button on top of the PIR transmitter
unit once.
unit once.
7.
The receiver should sound to indicate it has learned the
transmitter. If that does not happen, repeat steps E-G.
transmitter. If that does not happen, repeat steps E-G.
8.
Release the TEACH button.
9.
To confirm that the receiver has learned the transmitter, press and
release the button on top of the PIR Transmitter one time. The
receiver will sound to indicate it has received an alarm signal.
release the button on top of the PIR Transmitter one time. The
receiver will sound to indicate it has received an alarm signal.
2.
Mount the PIR Transmitter onto a solid surface, 5 (or more) Feet high and 5-20 feet from
the road, as shown.
the road, as shown.
3.
Angle the unit down a bit.
4.
Use the included “SILVER TAPE” to limit the vision of the lens as shown on the next
page.
page.
5.
The unit is waterproof with the cover installed… However, It is best to protect the unit
from direct rain or harsh wind. A simple wooden cover, or a cut-out plastic bottle could
make a great shelter.
from direct rain or harsh wind. A simple wooden cover, or a cut-out plastic bottle could
make a great shelter.
6.
SENSITIVITY SETTING: There is a Jumper Shunt inside the unit, marked J1. The
unit’s sensitivity is set with this shunt.
unit’s sensitivity is set with this shunt.
-
Shorted= Very Sensitive.
Plastic Plate..
Mount with 2 or
3 Screws, as
shown.
Mount with 2 or
3 Screws, as
shown.
PIR Transmitter
unit. Mount with
Window on
BOTTOM, as
shown.
unit. Mount with
Window on
BOTTOM, as
shown.
Attach to a
surface with
screws. Place the
screws on the
bottom of the
bracket ONLY.
surface with
screws. Place the
screws on the
bottom of the
bracket ONLY.
After attaching the Plastic
Bracket, peel the backing
from the PIR 2 sided tape
and apply to the bracket.
Make sure that the unit is
mounted so that the cover
can slide over it. Do not
mount below the screws.
Bracket, peel the backing
from the PIR 2 sided tape
and apply to the bracket.
Make sure that the unit is
mounted so that the cover
can slide over it. Do not
mount below the screws.
Non Metallic
Surface
Surface
Relay
Output
Output
Teach Button
Switches for “Sound
Duration” and
“Sound Mute”
Duration” and
“Sound Mute”