Zebex Industries Inc BT-CRADLE 用户手册
Once the scanner is well situated in the cradle, press down any one of the
small buttons at the side of
small buttons at the side of
LED lamp to start charging (Shown as Figure).
Figure Press any one to start charging
The LED of scanner light in RED as in charge, and light in BLUE when full
charged. Refer to Chapter 9 for LED indication.
We call this “Smart Charge”, as battery life is well depended on the
charging number of times, so only charge the batteries when necessary by
following the abovementioned procedures to prolong your battery life.
You may also set up auto-charging as every time the scanner is placed
into the cradle. Follow and scan the appropriate barcode symbols to set
up from programming section of this booklet
Note:
charged. Refer to Chapter 9 for LED indication.
We call this “Smart Charge”, as battery life is well depended on the
charging number of times, so only charge the batteries when necessary by
following the abovementioned procedures to prolong your battery life.
You may also set up auto-charging as every time the scanner is placed
into the cradle. Follow and scan the appropriate barcode symbols to set
up from programming section of this booklet
Note:
For first charging, always charge the batteries over 6 hours
continuously to prolong your battery life.
After every full charge, you may use the scanner for 8 hours
continuously.
Recommended charging environment is temperature in 0°C~35°C
(32°F~95°F).
2.2. Connecting the Cradle
There are two types of cradle to select for this scanner.
Charging
Cradle
Cradle
Host
Charging Cradle
This cradle designs for battery charging only, it does not support radio
communication. Simply connect the external DC-9V9W power adapter
into it and place scanner into cradle to start charging.
When charging is not required, it is recommended to remove the adapter
plug to retain the battery life.
7