Zebex Industries Inc BT-CRADLE 用户手册
3.
Pairing Scanner and Cradle Host
This scanner supports three radio communication types,
Cradle
Host,
SPP (Serial Protocol Profile) Slave
SPP (Serial Protocol Profile) Master.
SPP (Serial Protocol Profile) Master.
3.1. Cradle
Host
The scanner and communication cradle in the same delivery box are
paired in factory, as soon as both are powered on, it should find and
connect to each other immediately.
However, in any circumstance that scanner and cradle are not paired with
the cradle, follow steps below to redo pairing.
1. Follow procedures in Section 2.2 to connect the cradle and charging
the scanner.
2. Power on the cradle and it should light in RED first than LED flashes
“BLUE”, and it is ready for pairing.
3. Place the scanner into cradle until a short beep heard to confirm
position correctly.
4. Hold down simultaneously the two buttons at the side of cradle LED
lamp (shown as Figure ) for over 2 seconds.
Figure
The cradle LED lights in RED and the scanner beeps as a
High-Low-High beep tone, and then the scanner and cradle both LED
flashes. If pairing is success, you will hear Low-High beep tone and
cradle LED stays in BLUE and scanner LED stays in GREEN.
High-Low-High beep tone, and then the scanner and cradle both LED
flashes. If pairing is success, you will hear Low-High beep tone and
cradle LED stays in BLUE and scanner LED stays in GREEN.
5. If the cradle is locked for pairing, or if scanner is not set in cradle host
mode, it beeps twice and GREEN LED on scanner puts out.
12