Lutron Electronics Company Inc 0060 用户手册
Installation
Radio Frequency Wireless Controller
One Touch Favorite Button
One Touch Favorite Button
Sivoia
®
QS wireless
English
Wireless Controller Operation
1
OPEN
PRESET
CLOSE
OPEN
ADJUST
CLOSE
XXX-XXX
XXX-XXX
1. Do not paint Wireless Controller.
2. Clean Wireless Controllers with a soft damp cloth only. Do not use
any chemical cleaners.
3. Do not mix LR,LRA or LRB frequency products.
4. Device uses two (2) CR 2016 batteries.
5. Meets the Society of Automotive Engineers (SAE) temperature
standards:-40°F (-40°C) to 235°F (113°C)
6. The range and performance of the Sivoia
2. Clean Wireless Controllers with a soft damp cloth only. Do not use
any chemical cleaners.
3. Do not mix LR,LRA or LRB frequency products.
4. Device uses two (2) CR 2016 batteries.
5. Meets the Society of Automotive Engineers (SAE) temperature
standards:-40°F (-40°C) to 235°F (113°C)
6. The range and performance of the Sivoia
®
QS Wireless system is
highly dependent on a variety of complex factors such as: Distance
between system components.Geometry of the home. Construction
of walls seperating system components or electrical equipment locate
near system components.
between system components.Geometry of the home. Construction
of walls seperating system components or electrical equipment locate
near system components.
Important Notes:
Please read before installing.
OPEN
PRESET
CLOSE
OPEN
ADJUST
CLOSE
XXX-XXX
XXX-XXX
Open:
Tap once: shades or drapes go to
open limit
Tap once: shades or drapes go to
open limit
Preset:
Tap once to recall a favorite shade or
drape position. The preset button can
be set up for any light level (see the
next section: Setting Preset and Favorite
Buttons on the wireless contoller
Tap once to recall a favorite shade or
drape position. The preset button can
be set up for any light level (see the
next section: Setting Preset and Favorite
Buttons on the wireless contoller
Close:
Tap once: shades or drapes go to
close limit
Tap once: shades or drapes go to
close limit
Raise:
Press upper white triangle button
to move shades or drapes toward
open limit.
Press upper white triangle button
to move shades or drapes toward
open limit.
Lower:
Press lower gray triangle button to move
shades or drapes toward close limit.
Press lower gray triangle button to move
shades or drapes toward close limit.
These Wireless Controllers are compatible with most Homelink equipped
vehicles. Please see the vehicle manufacturer’s instructions for
programming information. (LR prefix)
vehicles. Please see the vehicle manufacturer’s instructions for
programming information. (LR prefix)
Notes:
· The wireless EDU’s must be paired with the Wireless Contoller in order for
it to operate the wireless EDU.
· Batteries are included and are pre-installed. Battery lifetime is
approximately 5 years.
it to operate the wireless EDU.
· Batteries are included and are pre-installed. Battery lifetime is
approximately 5 years.
System Capacity:
· Each wireless controller can be paired with as many wireless EDU’s that
are within its range
· Each wireless EDU can be paired with up to 20 wireless controllers.
are within its range
· Each wireless EDU can be paired with up to 20 wireless controllers.
Basic Programming
2
Pairing an EDU and wireless controller
Enter pairing mode
a. Press and hold the Open Limit button
on the EDU until its LED flashes green
then turns steady to enter pairing mode.
on the EDU until its LED flashes green
then turns steady to enter pairing mode.
b. Press and hold the Close Limit button
on the EDU until its LED flashe green
the LED on the external antenna flashes
green.
on the EDU until its LED flashe green
the LED on the external antenna flashes
green.
2.1
Pairing controller to EDU
a. Simultaneously press and hold Open,
Preset, and Close buttons on the
wireless controller to be paired
(3 seconds) until the LED on the
antenna flashes green.
Preset, and Close buttons on the
wireless controller to be paired
(3 seconds) until the LED on the
antenna flashes green.
b. EDU will jog shade or drape back
and forth two times to confirm pairing
is complete.
and forth two times to confirm pairing
is complete.
2.2
Pairing additional controllers
a. Repeat step 2
2.3
Exit pairing mode
a. Press and hold Open Limit button
on the EDU until its LED flashes green
on the EDU until its LED flashes green
b. Press and hold Close Limit button
until LED flashes green then goes off.
until LED flashes green then goes off.
2.4
OPEN
PRESET
CLOSE
OPEN
ADJUST
CLOSE
OR
Note:
For all Wireless Switches set up to a Wireless Contoller the Raise Button
move shades or drapes toward open limit. The Lower Button will produce
no change.
move shades or drapes toward open limit. The Lower Button will produce
no change.
Symptom
Solution
Shade or drape will not move using
adjustment buttons on EDU.
adjustment buttons on EDU.
EDU is not powered - check EDU Power
by unplugging and re-plugging in EDU.
LED should flash for 5 seconds.
Shade or drape is obstructed on something -
Remove obstruction.
by unplugging and re-plugging in EDU.
LED should flash for 5 seconds.
Shade or drape is obstructed on something -
Remove obstruction.
Shade or drape does not fully open or
fully close.
fully close.
Limits have been set incorrectly - refer to
“Set open limit” and “Set close limit” sections.
Shade or drape is obstructed - Remove
obstruction.
“Set open limit” and “Set close limit” sections.
Shade or drape is obstructed - Remove
obstruction.
IR controls will not operate shade
or drape.
or drape.
IR transmitter does not have line-of-sight
to IR receiver
Out of range - move to within 40 ft (12 m)
of IR receiver
EDUs not assigned to IR receiver
IR receiver not plugged into any EDU within range
IR remote control batteries are not providing
power - replace them
to IR receiver
Out of range - move to within 40 ft (12 m)
of IR receiver
EDUs not assigned to IR receiver
IR receiver not plugged into any EDU within range
IR remote control batteries are not providing
power - replace them
Troubleshooting
3