Worthdata Inc B78 用户手册
11
three beeps will be higher in pitch than the other beeps had been. If they
aren't higher in pitch, repeat the steps on this page until you are successful at
changing the beep tone.
aren't higher in pitch, repeat the steps on this page until you are successful at
changing the beep tone.
Now that your beep tone is at the "highest" pitch, you may want to change it
back to "medium" or a different setting. Repeat the steps above, selecting the
option you prefer to "highest" in step 3.
When you've successfully changed the beep pitch, and are ready to configure
the reader for your specific application, scan Start Setup again. Continue
scanning topics and options until you've made all the changes you desire, and
then scan End Setup to complete setup. For keyboard models, pay attention to
Keyboard Country, Computer Interface, and Data Transmission Timing. For
serial models, pay attention to Baud Rate, Parity, and Data Bits. If you are
planning to use several RF Laser scanners with one base station, pay attention
to the Set ID parameter.
The next several pages will show you all of the various Wireless Reader
options. Default settings are shown in bold in this manual and marked with an
* on the Reader Setup Menu.
Beep Tone
Lowest
0
Low 1
Medium 2
High 3
Highest 4
None
Medium 2
High 3
Highest 4
None
5
Channel
Default Channel
0
•
The default Channel is always shipped as 0. There are 10 channels
in the USA and Canada. The Channel can be set by scanning the bar
coded Setup Menu.
in the USA and Canada. The Channel can be set by scanning the bar
coded Setup Menu.
•
All Lasers and associated Base Station must be set to the same
channel. If you have more than one RF Laser per Base Station, you
must set a unique ID in each RF Laser. (See SET ID.)
channel. If you have more than one RF Laser per Base Station, you
must set a unique ID in each RF Laser. (See SET ID.)
•
The Laser channel must match the channel on the Base station. See
Appendix A for information on changing the channel on the Base
from the shipped default channel of 0.
Appendix A for information on changing the channel on the Base
from the shipped default channel of 0.