JVC KENWOOD Corporation 31201110 用户手册

54

1 Press [SATL] to select Satellite mode.

•

The default downlink (435.9 MHz) and uplink
(145.9 MHz) frequencies appear.

•

 “TRACE”, “R”, and “SATL” appear to indicate
the current selections.

<DISPLAY>

2 On VFO A, tune to the downlink frequency of the

satellite.

3 Press [LSB/ USB/ AUTO] or [CW/ FSK/ REV] to

select LSB, USB, or CW mode.

4 Press [A/B] to select VFO B.

5 Tune to the uplink frequency of the satellite.

6 Press [LSB/ USB/ AUTO] or [CW/ FSK/ REV] to

select LSB, USB, or CW mode.

7 If you are using a directional antenna, adjust its

azimuth and elevation.

•

If you have a pass prediction program, you can
use it to identify the exact location of the
satellite.

•

If you are using a fixed omnidirectional
antenna, skip this step.

8 With time, fine tune to the changing downlink

frequency of the satellite using the Tuning control.

•

As you adjust the downlink frequency, the
Trace function automatically changes the uplink
frequency so that the sum of the two
frequencies is kept the same.

•

If necessary, press [A=B] to quit the Trace
function.  “TRACE” disappears.

•

The trace function can also change the uplink
frequency so that the difference between the
two frequencies is kept the same.  Press
[SPLIT].  “R” disappears.

You can also store all the above selections in up to 10
memory channels.  Press [M.IN], then turn the
MULTI/ CH control to select a channel from 0 to 9.
Press [M.IN] again to store the selection in the
channel.  To recall the desired channel  after storing,
rotate the MULTI/ CH control while in Satellite mode.

In order to use the MULTI/ CH control to change the
frequency when in Satellite mode, press [VFO/ M].
The MULTI/ CH LED turns off.