JVC KENWOOD Corporation 378703 用户手册

0

For Trunking channels, refer to “Making Group Calls (Digital)” and “Making 

Individual Calls (Digital)”, below.
1  Select the desired zone and channel using the Zone Up/  Zone Down or  

CH/GID Up/ CH/GID Down keys.

2  Press the key programmed as Monitor or Squelch Off to check whether or 

not the channel is free.

•  If the channel is busy, wait until it becomes free.

3  Press the microphone PTT switch and speak into the microphone.  Release 

the 

PTT switch to receive.

•  The LED indicator lights red while transmitting and green while receiving a signal.  

This indicator can also be disabled by your dealer.

•  For best sound quality, hold the microphone approximately .5 inches (3 ~ 4 cm) 

from your mouth.

■

  If a key has been programmed with 

Group or Group + Status, you can select 

a group ID from the list to make a call to those parties.  To select a group ID:
1  Press the key programmed as Group or Group + Status.
2  Press the  /  keys to select a group ID/name from the list that has been 

pre-entered into your transceiver.

•  The target group ID/name appears on the display.
•  If you are using a microphone keypad, you can enter a unit ID by pressing the 

DTMF keypad.

3  Press and hold the microphone PTT switch to make the call.

•

  Speak into the microphone as you would during a normal transmission.

■

  If a key has been programmed with 

Individual or Individual + Status, you 

can make calls to specified persons.
1  Press the key programmed as Individual or Individual + Status.
2  Press the  /  keys to select a unit ID/name from the list that has been  

pre-entered into your transceiver.

•  The target unit ID/name appears on the display.
•  If you are using a microphone keypad, you can enter a unit ID by pressing the 

DTMF keypad.

3  Press and hold the microphone PTT switch to make the call.

•

  Speak into the microphone as you would during a normal transmission.