JVC KENWOOD Corporation 39923120 用户手册

12

Select the desired zone using the GRP

 and 

 keys.  Each zone contains a 

group of channels.

Select the desired channel using the CH control.  Each channel is programmed 
with settings for transmitting and receiving.

• If programmed by your dealer, the transceiver will announce the zone and channel 

numbers as you change them.

Names can be programmed for zones and personalities.  Your dealer can set the 
]RQHQDPHWRDOHQJWKRIWRGLJLWV7RÀWRQWKHGLVSOD\SHUVRQDOLW\QDPHV
will shorten appropriately.  (KCH-14 models display only 12 digits).  For example, 
if the channel name is “–CHANNEL1–” and the zone name is “KENWOOD”, and 
your dealer sets the zone name to 4-digits, the following display will appear:

KCH-14 (12-digit display):

KENW–CHANNEL

KCH-15 (14-digit display):

KENW–CHANNEL1–

For Trunking channels, refer to “Making Group Calls” and “Making Individual 
Calls” on the following page.

1 Select the desired zone and channel using the GRP

 and 

 keys and the 

CH control.

2 Press (or press and hold) the key programmed as Monitor or Squelch Off to

check whether or not the channel is free.

• If the channel is busy, wait until it becomes free.

3 Press the microphone PTT switch and speak into the microphone.  Release 

the PTT switch to receive.

• The TX indicator lights red while transmitting.  The BUSY indicator lights green while 

receiving a signal.  This indicator can be disabled by your dealer.

• For best sound quality at the receiving station, hold the microphone approximately 

1.5 inches (3 ~ 4 cm) from your mouth.