JVC KENWOOD Corporation 407601 用户手册

2

Hex-headed 

screw

DC power cable

Mounting bracket

Antenna 

connector

Power input 

connector

Fuse

Black (–) cable

Red (+) cable

2 V vehicle 

battery

Microphone

5 x 6 mm

Self-tapping screw

Spring 

washer

Flat 

washer

4  Coil the surplus cable and secure it with a retaining band.

•  Be sure to leave enough slack in the cables so the transceiver can be removed 

for servicing while keeping the power applied.

n

For passenger safety, install the transceiver securely using the supplied mounting bracket and 

screw set, so the transceiver will not break loose in the event of a collision.

Note:  Before installing the transceiver, check how far the mounting screws will extend below 

the surface.  When drilling mounting holes, be careful not to damage vehicle wiring or parts.

1  Mark the position of the holes in the dash, using the mounting bracket as a 

template.  Using a 4.2 mm (5/32 inch) drill bit, drill the holes, then attach the 

mounting bracket using the supplied screws.

•  Mount the transceiver within easy reach of the user and where there is sufficient 

space at the rear of the transceiver for cable connections.

2  Connect the antenna and the supplied power cable to the transceiver.
3  Slide the transceiver into the mounting bracket and secure it using the 

supplied hex-headed screws.

4  Mount the microphone hanger in a location where it will be within easy 

reach of the user.

•  The microphone and microphone cable should be mounted in a place where they 

will not interfere with the safe operation of the vehicle.

When replacing the fuse in the DC power cable, be sure to replace it with a fuse of the same 

value.  Never replace a fuse with one that is rated with a higher value.