JVC KENWOOD Corporation 408000 用户手册
38
3 Press [VFO] (1s).
• Scan starts at the current frequency.
• The 1 MHz decimal blinks while scanning is in progress.
• To reverse the scan direction, rotate the
• The 1 MHz decimal blinks while scanning is in progress.
• To reverse the scan direction, rotate the
Selector clockwise
(or press
[UP]) <upward scan> or counterclockwise (or press
[DOWN]) <downward scan>.
4 To exit Band Scan, press [VFO] again.
p
rogram
s
CaN
You can limit the scanning frequency range. There are 3 memory
channel pairs (L0/U0 ~ L2/U2) available for specifying the start and
end frequencies. Program Scan monitors the range between the
start and end frequencies that you have stored in these memory
channels. Before performing Program Scan, store the Program
Scan frequency range to one of the memory channel pairs (L0/U0 ~
L2/U2).
■
Storing a Program Scan Frequency Range
1 Press [VFO].
2 Press [MENU] and rotate the Selector (or press [UP]/
2 Press [MENU] and rotate the Selector (or press [UP]/
[DOWN]) to select your desired frequency for the lower limit.
3 Press [F], [MR] then rotate the Selector (or press [UP]/
[DOWN]) to select a memory channel from L0 ~ L2.
4 Press [MR] to store the start frequency in the memory
channel.
5 Rotate the Selector (or press [UP]/ [DOWN]) to select your
desired end frequency.
6 Press [F], [MR] then rotate the Selector (or press [UP]/
[DOWN]) to select a channel from U0 ~ U2, corresponding to
the channel selected in step 4.