Wi Lan Inc EB02 用户手册
Hardware Description
APR 2001 Rev 03
9
Rear Panel
Items located on the back panel are described below:
Antenna
N-type female connector antenna port is located at the top left of the rear
panel. This port should always be connected to an antenna directly or
through a 50 ohm coaxial cable
panel. This port should always be connected to an antenna directly or
through a 50 ohm coaxial cable
Serial Port
RS-232, DB9 connector used to communicate with a PC. Use this port to
locally configure and test a AWE
locally configure and test a AWE
Power
3-pin power connector. See
DC Power Plug Pinout
, page 148 for detailed
pinout illustration
Mode Button
Mode button can be used to set the operating mode of a unit without a
terminal. See
terminal. See
Setting Operating Mode with the MODE Button
, page 97 for
information about the mode button
Ethernet
Standard RJ45 female ethernet connector. To connect to a PC Ethernet card,
you must use the crossover twisted-pair cable. To connect to a hub, use a
straight-through twisted-pair cable
you must use the crossover twisted-pair cable. To connect to a hub, use a
straight-through twisted-pair cable
Link LED
Color of LED indicates the data rate and status of the twisted-pair
connection:
green = 10BaseT link, functioning properly
orange = 100BaseT link, functioning properly
off = No link
connection:
green = 10BaseT link, functioning properly
orange = 100BaseT link, functioning properly
off = No link
Air Vent
Air vent for unit’s internal cooling fan
Mode
Power
Antenna
Serial Port
Link
Ethernet
Antenna
Serial Port
Ethernet
Mode Button
Power
Link LED
Air Vent
Port