CALAMP WIRELESS NETWORKS INC. BDP4-EXCT769 用户手册
001-2019-500 Rev 0
Paragon4 – UHF, 700 & 800MHz User Manual
22
6.5 Web Interface
The Paragon4 user interface (Figure 13) is used to view and configure your network settings.
To navigate, use the top-level menus on the left, some of which expand to offer submenus, and display
the first submenu in the right-hand frame. Click the current submenu entry to refresh the right-hand
frame. The tables starting at section 6.6.1 below list action of each function. The interface main screen
lists available selections for the selected menu or presents instructions.
the first submenu in the right-hand frame. Click the current submenu entry to refresh the right-hand
frame. The tables starting at section 6.6.1 below list action of each function. The interface main screen
lists available selections for the selected menu or presents instructions.
Notes:
At any time, click the Help icon in the navigation pane to open a help text relating to the window
being displayed.
being displayed.
6.5.1 Apply, Cancel, Save Config, and Reset Unit Buttons & Help Icon
Several submenus have “Apply” and “Cancel” buttons.
The navigation area has “Save Config”, “Reset Unit” but-
tons and a Help icon.
tons and a Help icon.
If you “Apply” changes to any parameters marked
you will need to do a “Save Config” and a “Re-
set Unit”.
When making an entry into a dialog box, click on Apply when satisfied to temporarily apply the value(s)
entered to the relevant parameter(s). If not satisfied, click on Cancel button to restore to the value(s)
present before a change was made.
entered to the relevant parameter(s). If not satisfied, click on Cancel button to restore to the value(s)
present before a change was made.
Note: Cancel command only affects the dialog boxes or option buttons in the opened window.
If needed, go to other submenu(s) and make more entries. Click Apply before leaving each window.
When finished, click the Save Config button to make all changed entries permanent.
When finished, click the Save Config button to make all changed entries permanent.
Notes:
“Apply” writes to RAM, thus failure to use the “Apply” command button before leaving a web page
will result in the loss of temporarily entered selections, addresses, and values.
will result in the loss of temporarily entered selections, addresses, and values.
“Save Config” writes in flash, thus failure to use the “Save Config” command button will result in
the loss of temporarily entered parameters. A “Reset” is required to make flash changes take effect.
the loss of temporarily entered parameters. A “Reset” is required to make flash changes take effect.
Click on Save Config button:
If there are changes to be saved, saving occurs right away
If there are no changes to be saved, a pop-up window prompts user to confirm saving anyway
Click on “Reset Unit” button:
If there are changes to be saved, a window prompts user to confirm resetting.
If there are no changes to be saved, resetting occurs right away
A “Station Reset” 20-second timer counts down while the status reports: “Working…”
When done, the status reports: “Ready”.