DEI Headquarters Inc. AESVG10 用户手册

The current section only applies to an AstroStart security system (added as an option) which must not be confused with the 
vehicle’s OEM system.      

Your security system can use up to six different monitoring devices simultaneously to protect your vehicle.  
These devices are connected to the system on different inputs called protection zones.  
One of these zones can send an audible warning (7 chirps), while the other five generate an alarm condition if system is 
armed. 
 

Pre-shock (Warning)  

Siren chirps (7 times) 

Pre-shock (more than 3 times in 3 
min.) 
Doors 
Hood  
Additional sensor (Trunk) 
Shock sensor  
Ignition (key) 

Siren on for 30 or 60 second period, which can be repeated up to 4 times 
depending on initial programming and whether violated zone is corrected or 
not.  

 

Each period is separated by a 5 second pause. (45 seconds for "Door" 
zone). 

ACTIVE  
When one of the monitoring devices detects a violation, system reacts by activating the following deterrents, depending on 
which is connected.  
System can activate up to four deterrents simultaneously: siren, parking lights, dome light and/or horn. 
PREVENTIVE 
Depending on system’s configuration, the indicator light shows different alarm conditions (see "Zone Codes" on 
page 12).   
It can also act as a deterrent if installed in a place visible from outside vehicle. 

WARNING 
Warning signal is 7 siren chirps.  
If a two-level shock sensor is connected to system, warning sounds every time vehicle is subjected to a light shock when the 
alarm is armed. 
PRE-ALARM 
If you set off the alarm by accident and do not want to alarm or disturb the whole neighbourhood, "pre-alarm" mode cuts in 
three seconds before the alarm condition to give you time to disarm the system. 
In this mode, parking lights, siren and dome light go on and off intermittently for three seconds.  
ALARM CONDITION 
When system is in alarm condition, it activates the various deterrents connected to the alarm module.  
Alarm condition remains active for 30 or 60 seconds depending on initial programming, and then system pauses for five 
seconds (45 seconds for "Door" zone). During this pause, it checks the protection zones again and restarts alarm cycle if a 
zone is still in violation. 
This cycle can be repeated up to four times. If situation that caused the violation is corrected in mid-cycle, alarm stops at 
end of current cycle.