Digital Security Controls Ltd. 17LE4010 用户手册
22
# of
Flashes
Trouble Type
Trouble Notes
Red Blue
On
On
No Signal Strength
l
Verify SIM card is activated.
l
Ensure the antenna cable is plugged securely into the radio connector.
l
If the SIM is active, connect a battery to the unit and test various locations for
good/excellent signal strength.
l
Connect an antenna extension kit (LTE-8ANT, LTE-15ANT, LTE-25ANT, LTE-
50ANT).
1
Off
Wireless Network Trouble
l
Ensure the SIM card has been activated.
l
The antenna cable should be plugged securely into the radio connector.
l
Ensure there is good signal strength (at least one green light ON).
l
Verify the installation area is not experiencing a network outage.
2
Off
Battery Trouble
l
If a battery is not used in the installation, ensure that the "Internal Battery Con-
nected" is not selected in C24 Communications.
l
If a battery is used in the installation, verify the battery is connected properly
l
Measure the battery under load and verify it is charged to at least 12.5VDC. If not,
wait at least 1 hour for the battery to charge.
l
Remove the battery and measure the voltage; the voltage should be at least 12VDC.
l
Verify the input DC supply is rated at 13.8VDC @ 180mA minimum.
l
Replace battery
3
Off
Input Power Trouble
l
Ensure the power source connected to the 3G4010/LE4010 is providing 13.8VDC
@ 180mA.
1
Flash Insufficient Signal Strength
l
Ensure the antenna cable is plugged securely into the radio connector.
l
If the SIM is active, connect a battery to the unit and test various locations for
good/excellent signal strength.
l
Connect an antenna extension kit (LTE-8ANT, LTE-15ANT, LTE-25ANT, LTE-
50ANT)
2
Flash Not Used
3
Flash
C24 Communications Con-
figurations Trouble
figurations Trouble
l
Ensure the SIM card is activated and correctly initialized through C24 Com-
munications.
1
On
Radio/SIM Trouble
l
Ensure the SIM Card is inserted correctly and firmly.
l
Ensure the antenna cable is plugged securely into the radio connector.
2
On
Receiver Not Available
Trouble
Trouble
l
Contact the monitoring station to verify that the 3G4010/LE4010 programming is
correct (port, IP address, DNIS).
l
Contact your central station to verify they are not experiencing any receiver issues.
3
On
Supervision Trouble
l
Contact your central station to verify they are not experiencing any receiver issues.
4
On
Tamper Trouble
l
Ensure the front cover is secured and the case tamper is closed.
The Red light will flash to indicate various trouble conditions outlined previously. If multiple trouble con-
ditions are present, the red light will flash according to the highest priority trouble. For example, if both a
3G4010/LE4010 wireless network trouble (one flash) and a low battery trouble (two flashes) are present; the
red light will flash one time. Once the 3G4010/LE4010 wireless network trouble condition is corrected, the
red light will then begin flashing two times.
ditions are present, the red light will flash according to the highest priority trouble. For example, if both a
3G4010/LE4010 wireless network trouble (one flash) and a low battery trouble (two flashes) are present; the
red light will flash one time. Once the 3G4010/LE4010 wireless network trouble condition is corrected, the
red light will then begin flashing two times.
3G4010/LE4010 Installation Manual