Digital Security Controls Ltd. 17TL280LER 用户手册
[971] - EEPROM Map Version
[972] - Virtual Keypad Language Version
[976] - Radio Configuration File Version
[977] - Cellular Network Provider - MCC/MNC Code
[978] - Cellular Network Type
00 GPRS
2G
04 LTE
4G
01 EDGE
2G
05 LTE Advanced 4G
02 WCDMA 3G
06 CDMA
2G
03 HSDPA 3G
07 EVDO
3G
[979] - Cellular Network CSQ
[980] - Radio Reset Codes
[981] - Radio Type
[982] - Radio Firmware Version
[983] - Firmware Update Diagnostics Section
Firmware updates for panel and the communicator itself can be made from the communicator.
Firmware updates for panel and the communicator itself can be made from the communicator.
Table 14: Response Code Descriptions and Corresponding Actions
Response
Code
Description of Response Code
Corresponding Action
Bad File
00
Version check failed
Contact DSC Tech Support, described the action
attempted with the system and supply them with the
Response Code in Section [983].
attempted with the system and supply them with the
Response Code in Section [983].
01
Image type mismatch
02
Device type mismatch
03
Hardware type mismatch
04
General variant mismatch
05
Firmware header wrong length
Panel is Busy
20
System update pending - panel is
armed
armed
Disarm the panel to continue with system firmware
update process.
update process.
21
System update pending -AC trouble
(Any AC trouble; device/module)
(Any AC trouble; device/module)
Resolve the AC trouble to continue with system
firmware update process.
firmware update process.
22
System update pending -low battery
(Any low battery trouble;
device/module)
(Any low battery trouble;
device/module)
Resolve the low battery trouble to continue with
system firmware update process.
system firmware update process.
25
System update pending -
communication in progress
communication in progress
Retry in a few minutes; if issue persists, contact DSC
Tech Support.
Tech Support.
Firmware Update Sequence Change
A0
System firmware update successful
None
A1
System firmware update failure
At least one module was not updated. Use DLS to
reapply the firmware to the module not updated.
reapply the firmware to the module not updated.
A2
System firmware update failure -
module not found
module not found
At least one module was not responding during
firmware update. Ensure all modules enrolled are
physically connected and powered up.
firmware update. Ensure all modules enrolled are
physically connected and powered up.
AA
Device firmware transfer begin
None
AB
Device firmware module update
begin
begin
None
39