Digital Security Controls Ltd. 18LE2077 用户手册

30

[214] Cellular Receiver 2 Port

Default (0BF5/3061)

This Section defines the port of Cellular Receiver 2. Change the value of this port when your

installation is located behind a firewall and must be assigned a particular port number, as

determined by your central station system administrator. Valid range: 0000 - FFFF.
NOTE: Do not program Cellular Receiver 1 and Cellular Receiver 2 to communicate to the same

receiver.

[215] Cellular Receiver 2 APN

Default (  )

The APN determines the Cellular network that the Communicator will connect to. This

information is available from your network carrier. Program this Section with up to 32 ASCII

characters.
NOTE: When a SIM card with a custom APN is used, the unit will not have access to the internet.

DLS and remote flash can still be done if Section [221] is programmed with a valid

Public APN.

[216] Cellular Receiver 2 Domain Name

Default (  )

i

Programming this Section is not permitted on a UL/ULC listed system.

Enter the Cellular Receiver 2 Domain Name with up to 32 ASCII characters.

C

ELLULAR

 O

PTIONS

[221] Cellular Public Access Point Name

Default (  )

When the Communicator is operating on a private APN, use this Section to select a public APN

for DLS and Remote Firmware Update. This information is available from your network carrier.

The APN identifies the public Cellular network that the Communicator will connect to.
[222] Cellular Login User Name

Default (  )

Some network carriers require you to provide login credentials when connecting to an APN.

Program your login User Name in this Section. Format is up to 32 ASCII characters.
NOTE: This Section is not accessible via SCW keypad programming.
[223] Cellular Login Password

Default (  )

Some network carriers require you to provide login credentials when connecting to an APN.

Program your login Password in this Section.
Format is up to 32 ASCII characters.
[224] Cellular Test Transmission Time of Day

Default (9999)

Enter a 4 digit value using the 24-hour clock format (HHMM) to set the test transmission time of

day. Valid range: 00-23 for the hours (HH) and 00-59 for the minutes (MM).
NOTE: To disable the test transmission time of day enter 9999 or FFFF in this Section.
The internal date and time will be automatically programmed by the primary receiver only.
[225] Cellular Test Transmission Cycle 

Default (000000)

This value represents the interval in between test transmissions in minutes. Valid range:

000000 - 999999 minutes. Once the unit has sent the initial periodic test transmission, all

future test transmissions will be offset by the programmed number of minutes. See Sections

[026] - [029].

Table 14: Cellular Test Transmission Interval

Test Transmission Interval

Daily

Weekly

Monthly

Programmed Minutes

001440

010080

043200